Command line Jack clients to transmit full quality multichannel audio over a
local IP network, with adaptive resampling by the receiver(s). Zita-njbridge can
be used for a one-to-one connection (using UDP) or in a one-to-many system
(using multicast). Sender and receiver(s) can each have their own sample rate
and period size, and no word clock sync between them is assumed. Up 64 channels
can be transmitted, receivers can select any combination of these. On a lightly
loaded or dedicated network zita-njbridge can provide low latency (same as for
an analog connection). Additional buffering can be specified in case there is
significant network delay jitter. IPv6 is fully supported.
Remove WWW entries moved into port Makefiles
Commit b7f05445c00f has added WWW entries to port Makefiles based on
WWW: lines in pkg-descr files.
This commit removes the WWW: lines of moved-over URLs from these
pkg-descr files.
Approved by: portmgr (tcberner)
Add WWW entries to port Makefiles
It has been common practice to have one or more URLs at the end of the
ports' pkg-descr files, one per line and prefixed with "WWW:". These
URLs should point at a project website or other relevant resources.
Access to these URLs required processing of the pkg-descr files, and
they have often become stale over time. If more than one such URL was
present in a pkg-descr file, only the first one was tarnsfered into
the port INDEX, but for many ports only the last line did contain the
port specific URL to further information.
There have been several proposals to make a project URL available as
a macro in the ports' Makefiles, over time.
(Only the first 15 lines of the commit message are shown above )
audio/jack: Update to Jack2: 0.125.0 -> 1.9.16
Big thank you to Florian Walpen <dev@submerge.ch> and
Goran Mekić <meka@tilda.center> for working on Jack2.
PR: 251125
Submitted by: Florian Walpen <dev@submerge.ch> (original version)
