nvramtool is a utility for reading/writing coreboot parameters and
displaying information from the coreboot table. It is intended for x86-based
systems (both 32-bit and 64-bit) that use coreboot.
The coreboot table resides in low physical memory, and may be accessed
through the /dev/mem interface. It is created at boot time by coreboot, and
contains various system information such as the type of mainboard in use. It
specifies locations in the CMOS (nonvolatile RAM) where the coreboot
parameters are stored.
For information about coreboot, see http://www.coreboot.org/.
Remove WWW entries moved into port Makefiles
Commit b7f05445c00f has added WWW entries to port Makefiles based on
WWW: lines in pkg-descr files.
This commit removes the WWW: lines of moved-over URLs from these
pkg-descr files.
Approved by: portmgr (tcberner)
Add WWW entries to port Makefiles
It has been common practice to have one or more URLs at the end of the
ports' pkg-descr files, one per line and prefixed with "WWW:". These
URLs should point at a project website or other relevant resources.
Access to these URLs required processing of the pkg-descr files, and
they have often become stale over time. If more than one such URL was
present in a pkg-descr file, only the first one was tarnsfered into
the port INDEX, but for many ports only the last line did contain the
port specific URL to further information.
There have been several proposals to make a project URL available as
a macro in the ports' Makefiles, over time.
(Only the first 15 lines of the commit message are shown above )
nvramtool is a utility for reading/writing coreboot parameters and
displaying information from the coreboot table. It is intended for x86-based
systems (both 32-bit and 64-bit) that use coreboot.
The coreboot table resides in low physical memory, and may be accessed
through the /dev/mem interface. It is created at boot time by coreboot, and
contains various system information such as the type of mainboard in use. It
specifies locations in the CMOS (nonvolatile RAM) where the coreboot
parameters are stored.
For information about coreboot, see http://www.coreboot.org/.
WWW: http://www.coreboot.org/Nvramtool
PR: ports/155583
Submitted by: Andrey Zonov <andrey at zonov.org>
