django-tables2 simplifies the task of turning sets of data into HTML tables.
It has native support for pagination and sorting, does for HTML tables what
django.forms does for HTML forms.
NOTE: If this package has multiple flavors (see below), then use one of them instead of the name specified above. NOTE: This is a Python port. Instead of py312-dj60-django-tables2 listed in the above command, you can pick from the names under the Packages section.
===> The following configuration options are available for py312-dj60-django-tables2-2.8.0:
TABLIB=off: Enable support for exporting table datasets
===> Use 'make config' to modify these settings
www/py-dj60-django-tables2: Set PORTSCOUT
* The only consumer, net-mgmt/netbox, is currently incompatible with
newer versions due to breaking changes.
Therefore, set PORTSCOUT temporarily until net-mgmt/netbox has been
updated to the upcoming 4.7.x release.
net-mgmt/netbox: Create Django 6.0 consumers
* Django 5.2 is currently the "default" version in the ports tree due
its long term support until April 2028. Thus ports that are assigned
to that version will exist until then.
The following ports are required to make the upgrade of
net-mgmt/netbox to the 4.6 release possible because it requires
Django 6.0.
All of the ports listed below were created on the basis of their
respective original ports:
- devel/py-dj60-django-rq
- devel/py-dj60-strawberry-graphql
(Only the first 15 lines of the commit message are shown above )
